Walton Ultima Dry Iron Price In Bangladesh

General Specification

Spray Button

Burst of Steam Button

Steam Control Knob

Water Fill Opening

Spray Nozzle

Max Water Level

Soleplate

Temperature Dial

Water Tank

Ready Light

Self Cleaning Button

FILLING WITH WATER

Ensure the iron is disconnected from the power supply.
Turn the steam control knob to position “0”
Fill with water through water filling inlet(Do not exceed main level mark on the water tank.)

SETTING THE TEMPERATURE

**Synthetics-Silk
**Wool
***Cotton -Linen
Stancl the iron uprght
Set temperature control to ironing temperature.
Inset the mains plug into the main supply.
After the indicator light has gone out and come on again, you may start ironing. The indicator light will go out from time to time during ironing.

STEAM-IRONNING

Sit the temperature rotitlol to position for moderate steam and to for maximum steam.
With conventional steam iron, water may leak from the, sole plate if a too low temperature
has been selected.

Ensure that there is enough water in the water reservoir.
Stand the iron on its heel
Insert the mains plug into the wall socket.
Wait a little while for the indicator light to go out and come on again.
See the variable steam knob to adjust the steam.

BURST OF STEAM

By pressing button and intense “Burst “of steam is emitted from the sole plate.
To prevent water leaking from the sole plate, do not keep the steam control button depressed for more than 5 seconds

SPRAY SETTING

At any temperature by pressing the spray Button a couple of time the laundry can be damped down.
Ensure that there is enough water in the water reservoir.

DRY IRONING

Turn the variable steam knob to the position “O”(-no steam).

STORAGE

Remove the mains plug from the wall socket.
Pout any remaining water out of the water reservoir.
Set the steam knob to no steam position,
Stand the iron upright and let it cool down sufficiently.

CLEANING

Before cleaning the iron ensure it is disconnected from the power supply and has completely cooled down.
Deposits on the sole plate may be removed with a rough cloth soaked in a vinegar /water solution.
The casting may be wiped with a damp cloth and then polished with a dry one.
Do not use abrasives on the sole plate.
Keep the sole plate smooth. Avoid hard contact with metal objects.

Specifications are subject to change without any prior notice.